![]() ![]() Ls/dev/tty (mac users must enter ls/dev/tty.*)Īs shown in image above you will see /dev/ttyUSB0, ensure that you have not connected other USB devices in that case the USB1, 2 or x. You will see something like FTDI USB serial Device converter now connected to or cp210x in this case attached to “ ttyUSB0” After opening terminal you need to use the following command lines to see if your device is properly recognized by your system or not. Additionally while connected to more than one module we can see you have to be a bit more careful. You can detect your XBee radio module in Linux and Mac OSX, by opening a Terminal, you can type a few commands to see if the module is recognized by your computer. In the end, we will be able to send text from one computer to another like a Chatting application.ĭetecting attached XBee module in Computer: In this tutorial we will interface two XBee modules with two Computers and make the computers communicate wirelessly using those XBee modules. In previous tutorial we have learned about ZigBee protocol, its architecture and also learned about XBee modules and AT Commands. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |